3D-printed parts
Creality Hyper Series PETG.
Download the STL files from Printables, Creality Cloud, MakerWorld.
Gallery
Real-world examples of Aerothrow and WIT Motion sensors.
Assembly complete
To assemble a single set, you will need 2 M2x5mm and 4 M3x6mm screws. Tighten the M3 screws firmly but not too tightly, so as not to tear the material.
In use or not in use
To maintain the clamp’s maximum strength, it is advisable to raise the feet when the device is not in use.
A piece of rubber inner tube stuck under the feet will help keep the clamp in place.
Aircraft Setup
Remember to measure the width of your spoiler/flap/elevator/rudder at the point indicated in the assembly instructions, not where the sensor is located!
Possible ?
The exact position isn’t important; it’s the angle that’s measured in degrees.
However, it is essential to position the clamp at a 90° angle to the axis of rotation.